Table of Contents
Advertisement
(2) Click the [SHADING] button of [MASKING ADJUST/EDGE BLENDING].
The [SHADING SETTING] screen is displayed.
Screen example
(3) Set "Position". (Only for the projector B)
"Position" is set depending on where the image overlaid portion (encircled by dotted line) is
located in the image of the projector that is not the reference one (In this case, "Left" for the
projector B)
Image of projector A
(4) Click "On" of the radio button in [Test Pattern].
2. Perform (1), (2) and (4) in step 1 with the SRX Controller of the projector A.
In the projector A, the Position setting (3) is not performed.
3. Select [Level1] in [Level] for both projector A and projector B.
4. Visually adjust R (Red), G (Green) and B (Blue) of the projector B using the [_]/[+] buttons.
5. Adjust [Level2] to [Level8] by repeating steps 3 and 4.
6. After completing the adjustment, click "Off" of the radio button in [Test Pattern].
7. Click the [CLOSE] button.
2-44 (E)
Image of projector B
SRX-T615
Advertisement
Table of Contents
