Table of Contents
Advertisement
1 [WHITE BALANCE]
Performs the Gain R/G/B adjustment for setting the color temperature.
It is used to adjust the subtle difference of color among the projectors when more than one projector is
used. When adjusting only one projector, use [Color Space Converter].
The default value is 50. During ordinary adjustment, use at a value of 50 or less. For a value of more than
50, a signal may be deformed.
Adjustment when more than one projector is used
1. Perform the CSC adjustment for all projectors. (Refer to Section 2-6.)
2. Project the 80% white signal.
3. Determine a projector to be used as reference. Adjust the gain value of other projectors so that the
color becomes the same as that of the reference projector.
2 [REGISTRATION ADJUST]
Moves R (red), G (green), and B (blue) in the horizontal and vertical directions up to two pixels, one pixel
at a time so as to adjust registration.
. On: Selects when adjusting.
. Off: Selects when not adjusting.
. H: Pixels move in the horizontal direction.
R: Red pixels horizontally move up to two pixels, one pixel at a time when you click the [+]/[_]
button.
G: Green pixels horizontally move up to two pixels, one pixel at a time when you click the [+]/[_]
button.
B: Blue pixels horizontally move up to two pixels, one pixel at a time when you click the [+]/[_]
button.
. V: Pixels move in the vertical direction.
R: Red pixels vertically move up to two pixels, one pixel at a time when you click the [+]/[_]
button.
G: Green pixels vertically move up to two pixels, one pixel at a time when you click the [+]/[_]
button.
B: Blue pixels vertically move up to two pixels, one pixel at a time when you click the [+]/[_]
button.
3 [LAMP CONTROL & INFORMATION]
Changes the time of the lamp used and the number of lamps.
Lamp information can be exported when you click the [INFO] button in [LAMP] and the [EXPORT]
button in the LAMP IMFORMATION screen.
. [Lamp Number Select]: Select the number of lamps.
. [Change Mode Select]: When "2" or "3" is selected in [Lamp Number Select], the switching mode can
be selected from "Auto" or "Manual".
In the Auto mode, select the interval time.
In the Manual mode, select the lighting pattern in [Lamp Select].
n
When "Auto" is selected in [Change Mode Select], another lamp automatically
lights in case that a lamp failure occurs. Therefore, the number of lamps is
maintained at all times.
The function does not operate when "6" is selected in [Lamp Number Select]
or when lamp power is defective.
SRX-T615
2-11 (E)
Advertisement
Table of Contents
