Table of Contents
Advertisement
1-1. Outline
1-1-1. Installation Flow
The installation procedure for this unit is shown in the flow chart.
For the details of each flow, refer to the corresponding item.
n
Basically there is no problem even if Sections 1-2 to 1-5 are not performed in sequential order. However,
do not connect the power cord in Section 1-6 before Sections 1-2 to 1-5 are completed.
Start the installation.
Install this unit.
Install the SRX Controller in a
personal computer (PC).
(Refer to the Operating
Instructions.)
Set this unit.
(Refer to Section 2-2.)
Only a 2D lens
is used.
Perform lens adjustment.
(Refer to Section 2-3.)
Perform registration adjustment.
(Refer to Section 2-5.)
Perform gamma and uniformity
adjustments using a Projector
Color Adjustment Tool.
Perform color space
correction (CSC adjustment).
(Refer to Section 2-6.)
Perform
edge blending
adjustment.
(Refer to Section 2-7.)
SRX-T615
Section 1
Installation
. 1-2. Installation of Duct
. 1-3. Installation of Lens
. 1-4. Installation of 3D Lens Filter (In the Case of LKRA-005)
. 1-5. Installation of Lamp
. 1-6. Connection of Power Cord
. 1-7. Adjustment of Projector Tilt
n
Perform gamma and uniformity adjustments before
installation when using only a 3D lens.
Only a 3D lens
is used.
Perform gamma and uniformity
adjustments using a Projector
Color Adjustment Tool with the
2D lens installed.
Install the 3D lens, then
perform image adjustment.
(Refer to Section 2-4.)
Perform registration adjustment.
(Refer to Section 2-5.)
Perform color space
correction (CSC adjustment).
(Refer to Section 2-6.)
2D and 3D
lenses are used.
Perform lens adjustment.
(Refer to Section 2-3.)
Perform image adjustment.
(Refer to Section 2-4.)
Perform registration adjustment.
(Refer to Section 2-5.)
Perform gamma and uniformity
adjustments using a Projector
Color Adjustment Tool with the
2D lens installed.
Perform color space
correction (CSC adjustment).
(Refer to Section 2-6.)
1-1 (E)
Advertisement
Table of Contents
