Table of Contents
Advertisement
2-4-4. Position Adjustment (Adjust Image Using SRX Controller)
The position adjustment of 3D lens in the horizontal direction is performed using the SRX Controller.
Although it can be performed using the H shift of lens shift block, the images projected by the 2D lens
and 3D lens cannot be adjusted to the same position because the image moves in the reverse direction due
to the mechanism of this unit.
1. Project a test pattern ("Frame Adjust"). (Refer to steps 1 to 4 in Section 2-4-1.)
Screen example
[SINGLE 3D ADJUST]
2. Click the "L/R Sync (Left)" radio button in [Image Select] of [SINGLE 3D ADJUST].
3. Adjust the image position in the horizontal direction in [H Adjust] of [Position Adjust].
2-4-5. Position Adjustment (Adjusting the Projector Tilt and Direction)
In the case that the V shift amount is insufficient, adjust the length of foot in the rear portion of this unit to
tilt the projector. (Refer to Section 1-7.) In the case that the H shift amount is insufficient, change this unit
installation position in order to project the image obliquely.
Perform the mask processing because a keystone occurs when this unit is tilted.
2-30 (E)
SRX-T615
Advertisement
Table of Contents
