Table of Contents
Advertisement
2-4-8. Brightness Adjustment
n
When the CSC adjustment is performed, the brightness changes slightly. After performing the CSC adjust-
ment, adjust the brightness again.
1. Start the SRX Controller, then click the [SERVICE] tab. (Refer to Section 2-1-3.)
The [SERVICE] screen is displayed.
2. Select the "Gray-10" in [Test Pattern Select] of the [COLOR SPACE CONVERTER].
[SERVICE] tab
Screen example
[COLOR SPACE CONVERTER]
3. Click the [INSTALLATION] tab.
Screen example
[LAMP POWER]
4. Select an appropriate luminance level from the three levels in the [LAMP POWER].
t Level 3 is the brightest level.
5. Perform the fine adjustment using [+] and [_] buttons.
6. Check the brightness using the luminance meter.
2-34 (E)
SRX-T615
Advertisement
Table of Contents
