Table of Contents
Advertisement
1-3. Installation of Lens
n
. When performing the installation/removal of lens, be sure to shut down this unit by the SRX Controller,
then turn off the power switch on the rear side of this unit.
. When performing the installation/removal of lens, be careful not to touch the lens board.
2D lens
t
Although the illustration used here for description is the 2D lens, the installation procedure for the 3D lens
is the same as the 2D lens.
1. Raise the lens fixing lever toward the "
released).
n
If you raise the lens fixing lever without pushing the lock button, the lock button and lens fixing lever
will be damaged. Be sure to push the lock button and check that the lock is released before raising the
lever.
SRX-T615
3D lens
Board
" side with the lock button pushed all the way in (lock
Lock button
Board
Lens fixing lever
1-11 (E)
Advertisement
Table of Contents
