Table of Contents
Advertisement
2-7-3. Color Matching of Edge Blending
After performing the color space conversion (CSC adjustment) of the two projectors, if the color of the
image overlaid portion is different from the color of other portion, perform this adjustment.
Image of projector A
n
. Perform this adjustment after completing "2-6. Color Space Conversion (CSC Adjustment)". If the color
matching of edge blending is performed before the CSC adjustment, the entire adjustment may not be
able to be performed due to the lack of correction amount.
. Use one projector as the reference projector and adjust the other projector to the reference projector. Do
not change the values of the reference projector.
In this section, an example is described using the projector A as the reference projector.
1. Perform the following with the SRX Controller of the projector B.
(1) Start the SRX Controller, then click the [SERVICE] tab. (Refer to Section 2-1-3.)
The [SERVICE] screen is displayed.
[MASKING ADJUST/EDGE BLENDING]
Screen example
SRX-T615
Image of projector B
[SERVICE] tab
2-43 (E)
Advertisement
Table of Contents
