Creating User Programmable Dme Patterns; User Programmable Dme Transition Mode - Sony MVS-8000X System User Manual

Multi format switcher system

Hide thumbs Also See for MVS-8000X System:

Table of Contents

Creating User Programmable DME Patterns

With a user programmable DME, you can use DME effects created through the

use of keyframes for a transition on the switcher system.

Note the following points when creating a keyframe effect for use as a user

programmable DME pattern.

When saving a keyframe effect as a user programmable DME pattern, specify

the register number that corresponds to the pattern number as shown in the

following table.

Execution mode

One-channel mode

Two-channel mode

Three-channel mode

For details of registers and keyframe effects, see Chapter 13 "Keyframe

Effects" (Volume 2), respectively.

When the signal format is 1080P, three-channel mode cannot be used.

Keyframe effects in the global channel

When the effect with the same number as the reference channel is present on

the DME global (GLBL) channel, executing the user programmable DME will

also execute the effect on the global channel simultaneously.

When executing a user programmable DME, take note of whether the effect is

present on the global channel.

To create a user programmable DME, it is necessary to set the transition mode

(the way in which the effect moves). To set the transition mode, use the Key

Frame >DME User PGM menu.

For details of the operating procedures, see "Transition Mode Settings for

User Programmable DME" in Chapter 13 (Volume 2).

Creating User Programmable DME Patterns

Pattern number

1901 to 1999

2901 to 2999

3901 to 3999