Setting The Border Color - Sony MVS-8000X System User Manual

Setting the border color

The operation differs depending on the DME used (MVE-8000A or MVE-
9000).
When the MVE-8000A is used
Press [Border Color], turning it on, and set the following parameters.
Knob
1
2
3
When the MVE-9000 is used
Use the buttons in the <Border Fill> group to select the signal to insert in the
border.
Flat Color: single color
Mix Color: mix color signal set in the Color Mix menu (see page 533)
Ext Video: an external video signal input to the Ext IN connector
If Flat Color is selected, adjust the following parameters.
508
DME Special Effect Operations
• 16:9 mode
Knob Parameter
1 H
2 V
3 All
5 Density
Knob Parameter
1 Top
2 Left
3 Right
4 Bottom
5 Density
Parameter Adjustment
Luminance Luminance
Saturation Saturation
Hue Hue
Parameter group [1/2]
Adjustment
Border width on left and right
sides
Border width on top and bottom
sides
Border width on all sides
Border density
Parameter group [2/2]
Adjustment
Border width on top side
Border width on left side
Border width on right side
Border width on bottom side
Border density
Setting values
Left value shown
Top value shown
Left value shown
0.00 to 100.00
Setting values
–4.50 to +4.50 (SD)
–18.00 to +18.00 (HD)
–8.00 to +8.00 (SD)
–32.00 to +32.00 (HD)
–8.00 to +8.00 (SD)
–32.00 to +32.00 (HD)
–4.50 to +4.50 (SD)
–18.00 to +18.00 (HD)
0.00 to 100.00
Setting values
0.00 to 100.00
0.00 to 100.00
359.99 to 0.00