Sony MVS-8000X System User Manual page 175

color or two-color combination color matte. Select whether to use a single-
color matte or a two-color combination in the <Fill Matte> group.
Flat Color: Adjust color 1 with the following parameters.
Knob Parameter
1 Luminance
2 Saturation
3 Hue
Mix Color: Carry out a color mix. Adjust color 1 and color 2, and select a
mix pattern (see the next section).
5
In the <Key Source> group, specify the key source selection mode.
Self: The key fill bus signal is automatically selected as the key source.
When the key type is selected as chroma key, select [Self].
Auto Select: The signal allocated, being paired with the key fill bus signal,
to a cross-point button is automatically selected as the key source. The
setting of key fill and key source pairs is carried out in the Setup menu.
(See "Cross-Point Settings (Xpt Assign Menu)" in Chapter 19
(Volume 3).)
Split: You can select a key source signal independently of the key source
automatically selected in Auto Select mode.
6
When [Split] was selected in step 5, hold down the [KEY1] button and
press the appropriate button in the key row to select the key source signal.
To select the video signal assigned to the button, turn off the [KEY] button
in the AUX bus control block, and to select the key signal, turn on the
[KEY] button before pressing the button in the key row.
Notes
• Carrying out a [KEY] button operation in the AUX bus control block
requires the [KEY] button operating mode (Key Source Bus Select
Mode) to be set. With the factory default setting (Key), the [KEY] button
is always off, and it is only possible to select a key signal assigned to a
button as the key source signal.
For details, see "Operation Settings (Operation Menu)" in Chapter 19
(Volume 3).
• When [Split] is selected, the key memory function (see page 161) is
disabled.
Adjustment
Luminance
Saturation
Hue
Key Setting Operations Using Menus
Setting values
0.00 to 100.00
0.00 to 100.00
359.99 to 0.00
175