Sony MVS-8000X System User Manual page 204

Knob
3
4
a) In the "4H mode" and when [Fine Key] (page 181) is on, the setting value range is 0 to 4.
When [Outline] is selected with separate edge on, the [MORE] button lights
amber. Pressing the [MORE] button to turn it green then allows you to adjust
the key fill density parameter with a knob.
Knob
4
Setting the embossing parameters
When the [EMBOS] button is lit green, adjust the following parameters.
Knob
1
2
4
Selecting a normal edge
When all five edge type selection buttons are off, a normal edge is selected. If
one of the buttons is lit, press it, turning it off.
Softening the edge
Press the [SOFT EDGE] button, turning it on. The button lights green, and you
can now adjust the softness with the knob.
Knob
1
• For a normal edge, when [SOFT EDGE] is enabled, "Key Drop" mode turns
on.
• When a luminance key or linear key is selected as the key type, and clean
mode is enabled, enabling [SOFT EDGE] ends the clean mode.
Applying the zabton effects
When the [ZABTN] button is lit green, adjust the following parameters.
204
Key Setting Operations With the Key Control Block
Parameter Adjustment
Right Right edge width
Bottom Bottom edge width
Parameter Adjustment
Density Outline density
Parameter Setting values
Width 0 to 4
Position 359 to 0
Density 0 to 100
Parameter Adjustment
Soft Edge softness
Setting values
a)
0 to 8
a)
0 to 8
Setting values
0 to 100
Setting values
0 to 100