Sony MVS-8000X System User Manual page 277

To specify the DME wipe direction with a button in the transition
control block
In the transition control block of each of the M/E-1 to M/E-3 and PGM/PST
banks, press the following direction selection buttons.
NORM: Normal
NORM/REV: Normal/Reverse
REV: Reverse
Modifying the DME wipe pattern edge
1
In the M/E-1 >DME Wipe menu, select HF4 'Edge/Direction.'
The Edge/Direction menu appears.
2
Depending on whether the selected pattern is in one-channel mode or two-
channel mode, proceed as follows.
For a pattern in one-channel mode: press [1st Ch], turning it on.
For a pattern in two-channel mode: from the <Ch Select> group, select
the corresponding channel. You can select more than one channel at
the same time.
3
In the <Edge> group, select the edge type.
Border: border
Soft Border: soft border
4
Set the parameters according to the selection in step 3.
• When border is selected
Knob
1
3
4
5
• When soft border is selected
Knob
1
2
3
4
5
Parameter Adjustment
Width Border width
Luminance Luminance
Saturation Saturation
Hue Hue
Parameter Adjustment
Width Border width
Inner Soft Border inner softness
Luminance Luminance
Saturation Saturation
Hue Hue
Setting values
0.00 to 100.00
0.00 to 100.00
0.00 to 100.00
359.99 to 0.00
Setting values
0.00 to 100.00
0.00 to 100.00
0.00 to 100.00
0.00 to 100.00
359.99 to 0.00
Basic Procedure for DME Wipe Settings
277