Creating And Editing A Macro - Sony MVS-8000X System User Manual

3
Press the [ENTER] button.
This recalls the specified register.
When you recall an empty register
This assigns the numeric keypad control block and keyframe control block to
macro editing.
For details of macro editing, see "Creating and Editing a Macro" (see below).
When you recall a register holding a macro
This immediately executes the macro. While the macro is executed, the
[RCALL] button flashes.
Notes
• It is not possible to execute more than one macro at a time.
• If the same register is recalled again during macro execution or when the
macro is paused, the following operation depends on a setting in setup.
For details of the settings, see "Setting the Macro Execution Mode" in
Chapter 19 (Volume 3).
• Individual events stored in a macro are executed according to the settings in
setup. If you change the settings in setup, a saved macro may not have the
expected effect.
• During macro execution, if you switch the control panel to macro editing
mode, the macro being executed stops.
• During macro editing it is not possible to execute a macro.
• While executing a macro with a button with a macro attachment set, if you
recall another macro with the numeric keypad control block, the following
operation depends on a setting in setup.
For details of the settings, see "Setting the Macro Execution Mode" in
Chapter 19 (Volume 3).

Creating and Editing a Macro

Use the numeric keypad control block and keyframe control block to create and
edit a macro.
After carrying out creation and editing, be sure to carry out a save operation
(see page 800), using the numeric keypad control block.
Macro Operations in the Numeric Keypad Control Block and the Keyframe Control Block
793