Sony MVS-8000X System User Manual page 754

3
4
754
Snapshot Operations From the Numeric Keypad Control Block
It is not possible to select [MASTR] and other regions simultaneously. If
selected simultaneously, the master snapshot takes precedence.
The first pressed button lights green as the reference region, and
subsequently pressed buttons light amber.
Pressing one of the amber-lit buttons, while holding down [SNAPSHOT],
turns the button green to indicate its corresponding region as the new
reference region.
For details of the precedence order for becoming the reference region, see
"Reference region" (page 681).
The display shows the name of the reference region and the number of the
register previously recalled for that region.
Enter the desired register number from the numeric keypad.
See step 5 (page 752) in "Saving a snapshot from the numeric keypad
control block."
The entered register number appears in the display.
To apply temporary attributes, press the following buttons, turning them
on.
Control block Temporary
attribute to apply
Cross-point control A/B bus cross-point
block hold
Key cross-point hold [XPT HOLD] button
Numeric keypad Effect dissolve
control block
Auto transition
a) Enabled by a setup setting.
For the setup setting, see "Operation Settings (Operation Menu)" in
Chapter 19 (Volume 3).
For details of temporary attributes and available attributes, see "Snapshot
Attributes" (page 749).
Notes
• The cross-point hold and key disable settings are maintained until you
next press the [XPT HOLD] button.
• Applying temporary attributes does not affect the contents of the
register.
• It is not possible to apply temporary attributes to a master snapshot.
Button
[XPT HOLD] button in the
background A/B bus
a)
[+/–/EFF DISS] button
[CLR/AUTO TRANS] button