Dme Wipe Pattern Variation And Modifiers - Sony MVS-8000X System User Manual

Signals forming part of the background for a DME wipe
For a two-channel mode page turn, page roll, brick, frame in-out, and so on, the
part of the pattern shown in gray (see page 412) is filled with the signal selected
on the DME external video bus.
For three-channel mode brick, the part of the pattern shown in dark gray is
filled with the DME external video signal, and the light gray portion with the
signal selected as follows.
When the DME channel used is 3 or 4, the signal selected on the DME utility
1 bus. For channel 7 or 8, the signal selected on the DME utility 2 bus.

DME Wipe Pattern Variation and Modifiers

You can modify the selected DME wipe pattern in the same way as an ordinary
wipe pattern, as follows.
For the setting operations, see "Setting DME Wipe Modifiers" (page 276).
Direction: You can set the DME wipe direction to normal, reverse, or
Edge: You can apply a border or soft border (see page 277).
Positioner: You can move the DME wipe pattern or center of the effect to an
270
Overview
alternating normal/reverse (see page 276), except for a key transition,
which is always in normal/reverse mode. However, a key transition can
only be specified when the following patterns are selected, and when other
patterns are selected, this is fixed, as normal/reverse.
Patterns: 1204, 1207, 1221 to 1224
In the case of those user programmable DME patterns for keys in which an
edge has already been applied to the effect, the behavior is as follows.
• When the DME wipe edge setting is on, only part of the edge applied in
the effect is enabled, and that portion can be adjusted (page 277).
• When the DME wipe edge setting is off, the edge applied in the effect is
enabled as is.
arbitrary position. Using the position select function, you can also
instantaneously move the pattern.
• 1031
When this pattern number is selected, with the progress of the transition
the pattern center automatically moves initially from the set position
toward the center of the screen (see page 278). In other words, the effect
obtained is the same as in a normal wipe with the positioner set to
"AUTO CENTER".
• 1201 to 1208, 1221 to 1224, 1251
When these pattern numbers are selected, you can set the pattern position
when the first transition completes.