Sony MVS-8000X System User Manual page 796

3
Inserting an event
1
2
3
4
5
Modifying a single event
1
2
3
796
Macro Operations in the Numeric Keypad Control Block and the Keyframe Control Block
This assigns the numeric keypad control block and keyframe control block
to macro editing, and the [MCRO] button in the numeric keypad control
block and the [EDIT ENBL] button in the keyframe control block light red.
The [STORE] button in the numeric keypad control block flashes red.
Using any of the following methods, specify the edit point.
• To move the edit point to the event immediately following the current
macro event, press the [NEXT KF] button in the keyframe control block.
• To move the edit point to the event immediately preceding the current
macro event, press the [PREV KF] button in the keyframe control block.
• To move to an edit point by specifying an event number (the number
showing the position of the event in the macro execution sequence),
press the [GO TO KF] button in the keyframe control block, then in the
numeric keypad control block, enter the target number and confirm with
the [ENTER] button.
Specify the edit point. (See page 795.)
If required, press the [AUTO INS] button assigned to a utility/shotbox
control block or user preference button, to toggle the auto insert mode on
or off.
Create the event.
• When auto insert mode (see page 794) is on, the event is automatically
added to the macro.
• When auto insert mode is off, proceed to step 4.
When auto insert mode is off, press the [INS] button in the keyframe
control block.
Repeat steps 2 and 3 to insert the required events in the macro.
Specify the edit point. (See page 795.)
When the [AUTO INS] button assigned to a utility/shotbox control block
button or user preference button is lit, press this to turn the auto insert mode
off.
Create the event.