Add/Edit Policy Route - ZyXEL Communications LTE Series User Manual

7.4.1 Add/Edit Policy Route

Click Add New Policy Route in the Policy Route screen or click the Edit icon next to a policy. Use this
screen to configure the required information for a policy route.
Figure 58 Policy Route: Add/Edit
The following table describes the labels in this screen.
Table 23 Policy Route: Add/Edit
LABEL
Active
Route Name
Source IP
Address
Source Subnet
Mask
Protocol
Source Port
Source MAC
Source Interface
(ex: br0 or
LAN1~LAN4)
WAN Interface
Cancel
OK
Chapter 7 Routing
DESCRIPTION
Click this to enable (turns blue) activation of the policy route. Otherwise, click to disable (turns
gray).
Enter a descriptive name of up to 8 printable English keyboard characters, not including spaces.
Enter the source IP address.
Enter the source subnet mask address.
Select the transport layer protocol (TCP or UDP).
Enter the source port number.
Enter the source MAC address.
Type the name of the interface from which the matched traffic is sent.
Select a WAN interface through which the traffic is sent. You must have the WAN interface(s)
already configured in the Broadband screens.
Click Cancel to exit this screen without saving any changes.
Click OK to save your changes.
LTE Series User's Guide
72