Fax Problems; Problems Sending Faxes - Xerox Color C60 User Manual

Troubleshooting
Symptom
Lines or streaks only present in copies
made from the document feeder.
Spots present in copies taken from the
document glass.
The reverse side of the original is show-
ing on the copy or scan.
Image is too light or dark.
Colors are off.

Fax Problems

If a fax cannot be sent or received correctly, refer to the following table, then perform
the indicated operation. If a fax still cannot be sent or received correctly, even after
performing the described operations, contact your service representative.

Problems Sending Faxes

Symptom
The document is not
scanned using the docu-
ment feeder.
The document is scanned
at an angle.
10-16
Solution
There is debris on the document glass. When scanning,
the paper from the document feeder passes over the
debris creating lines or streaks. Clean all glass surfaces
with a lint free cloth.
There is debris on the document glass. When scanning,
the debris creates a spot on the image. Clean all glass
surfaces with a lint free cloth.
Copy: Turn on Background Suppression Scan: Turn on
Background Suppression
Copy: Use the Image Quality settings to lighten,
darken or adjust contrast. Scan: Use the Advanced
Settings tab to lighten, darken or adjust contrast.
Copy: Use the Image Quality settings to adjust color
balance. Scan: Confirm the correct Original Type is set.
Cause
The document is too thick, too
thin, or too small.
The document feeder guides
are not adjusted to the width
of the document.
Solution
Use the document glass to send
the fax.
Adjust the document feeder guides
to fit the width of the document.
Xerox ® Color C60/C70 Printer
User Guide