New Zealand - Xerox Color C60 User Manual

Pan-European Analog PSTN andCompatible PBX Certifications
France
Germany
This product has been tested to and is compliant with TBR21 OR ES 103 021-1/2/3 or
ES 203 021-1/2/3 technical specifications for terminal equipment for use on
analog-switched telephone networks in the European Economic Area.
If you have problems with your product, contact your local Xerox representative. This
product can be configured to be compatible with other country networks. Before
reconnecting the device to a network in another country, contact your Xerox
representative for assistance.
Note
Although this product can use either loop disconnect (pulse) or DTMF tone signaling,
Xerox recommends that you use DTMF signaling. DTMF signaling provides reliable and
faster call setup.
Note
Modification of this product, or connection to external control software or control
apparatus not authorized by Xerox, invalidates its certification.

New Zealand

1. The grant of a Telepermit for any item of terminal equipment indicates only that
Telecom has accepted that the item complies with minimum conditions for
connection to its network. It indicates no endorsement of the product by Telecom,
it does not provide any sort of warranty, and it does not imply that any Telepermitted
product is compatible with all Telecom network services. Above all, it provides no
assurance that any item will work correctly in all respects with another item of
Telepermitted equipment of a different make or model.
The equipment may not be capable of correct operation at the higher data speeds
designated. 33.6 kbps and 56 kbps connections are likely to be restricted to lower
bit rates when connected to some PSTN implementations. Telecom will accept no
responsibility for difficulties that arise in such circumstances.
2. Immediately disconnect this equipment should it become physically damaged, then
arrange for its disposal or repair.
3. This modem shall not be used in any manner which could constitute a nuisance to
other Telecom customers.
4. This device is equipped with pulse dialing, while the Telecom standard is DTMF tone
dialing. There is no guarantee that Telecom lines will always continue to support
pulse dialing.
5. Use of pulse dialing, when this equipment is connected to the same line as other
equipment, may give rise to 'bell tinkle' or noise and cause a false answer condition.
If you encounter such problems, do not contact the Telecom Faults Service.
Xerox ® Color C60/C70 Printer
User Guide
Luxembourg
Malta
Regulatory Information
Sweden
United Kingdom
15-13