Fault Codes - Xerox Color C60 User Manual

3. Close the right cover of the Trimmer unit.

Fault Codes

If a jam/fault occurs in the SquareFold Trimmer Module, the machine's UI displays a
jam/fault message. The following table provides a list of fault codes for the SquareFold
Trimmer Module and a list of related finisher fault codes.
Note
The top covers cannot be opened during normal operation or when the machine is idle.
The covers can be opened only when an indicator is lit and a jam/fault occurs within the
SquareFold Trimmer Module. For indicator details, refer to the control panel information
earlier in this section.
Fault Code Possible Cause
013-100013- Jam/fault with the SquareFold
101013-102013- Trimmer Module
103013-104013-
105013-106013-
303013-915013-
916013-917013-
918013-919
Xerox ® Color C60/C70 Printer
User Guide
SquareFold Trimmer Module
Recommended Solution
1. Open the Top Left and Right Covers
of the SquareFold Trimmer Module.
2. Carefully remove all sheets and
paper scraps from jam clearance
areas.
3. Close the SquareFold Trimmer
Module Top Left and Right Covers.
4. Check the Trimmer Waste Contain-
er:
• If full, empty the container and
reinsert it into the SquareFold
Trimmer Module
• If the container is partially pulled
out, push it completely in
5. If necessary, follow any remaining
instructions on the machine's UI.
6. If fault persists, repeat Steps 1-5; if
fault persists after that, call for ser-
vice.
14-15