Replacing A Fan Assembly - IBM Netfinity 5100 8658 11Y Manual

a. Unplug the power cord from the power supply.
Attention:
power supply; the power supply might be too hot to
handle comfortably.
CAUTION:
The following label indicates a hot surface nearby.
b. Remove the defective power supply by placing the
handle of the power supply in the open position
(perpendicular to the power supply) and pulling the
power supply from the bay.
3. Install a replacement power supply:
a. Place the handle on the replacement power supply
in the open position; then, slide the power supply
into the chassis.
b. Gently close the handle on the power supply to
seat the power supply in the bay.
c. Plug the power cord for the power supply into the
power cord connector.
d. Verify that the AC Power light and DC Power light
are lit, indicating that the power supply is operating
correctly.
4. Turn on the server and peripheral devices.
5. If you have other options to install or remove, do so
now; otherwise, go to "Installing the cover" on page 92.

Replacing a fan assembly

Your server comes with two fan assemblies.
Attention:
to help ensure proper cooling.
90
: Netfinity 5100 Type 8658 Models 11Y, 21Y, 31Y,
41Y, 51Y, 1RY, 2RY, 3RY, 4RY, 5RY
Be careful when you remove the
Replace a fan that has failed within 48 hours