Crankshaft Gearwheel And Stubshafts; M 02.00 Crankshaft; M 02.20 Crankshaft Gearwheel And - Hatz Diesel 1D30 S Workshop Manual

M 02.00 Crankshaft

M 02.20 Crankshaft gearwheel and stubshafts
- 12 - 14 -
General:
Crankshaft gearwheel respectively stub-
shaft are shrink fitted.
Preparations:
Ref.: M-Disassembly cross reference
scheme.
Dismantling:
– Remove gearwheel 1 respectively stub-
shaft 2.
For removal use tool - 14 -
Inspection / repair:
– Check gearwheel or stubshaft for wear
or any other damage.
Assembly:
– Put engine onto flywheel side (flywheel
fitted) to avoid damaging of flywheel side
thrust plate.
– Heat crankshaft gearwheel respectively
stubshaft.
In case heating is done on a heater
plate put parts onto special heating insert
- 12 - to obtain proper distribution of
heat over the whole part.
– Strike crankshaft gearwheel respectively
stubshaft onto crankshaft until final posi-
tion using a plastic tip hammer.
3
1D . . / 03.06