Dry Type Air Filter - Version A 02.11.3; Dry Type Air Filter - Version A 02.11.4 (A 1 D...) - Hatz Diesel 1D30 S Workshop Manual

A 02.00 Combustion air
A 02.11 Dry type air filters
–
Version A 02.11.3
Fixation of filter element by front cover
assembly.
Preparations: –
Dismantling:
– Disconnect cable connection from heater
flange if so fitted.
– Remove in numerical sequence 1...11.
– If necessary dismantle cover retaining
assembly to replace sealing sleeve (rub-
ber) between centering and front cover.
Inspection / repair:
– Visual inspection.
– Check filter element 2 and sealing strip
around cover 1.
Maintenance according to instruction book!
Assembly:
– Assemble in reverse sequence 11...1.
Take care for correct position of insulating
flange in between, correct amount of
gaskets and proper sealing of all parts to
avoid infiltrated air.
– Reconnect cable connection to heater
flange if so fitted.
2
1D . . / 03.06
Version A 02.11.4 (A 1 D...)
Fixation of filter element separately by retai-
ning plate, flat washers and Hex.-nuts.
Preparations: –
Dismantling
– Disconnect cable connection from hea-
ter flange if so fitted.
– Remove in numerical sequence 1...15.
Inspection / repair:
– Visual inspection.
– Check filter element 8, „O"-Ring around
retaining cover 11 and insulation plate 12.
Maintenance according to instruction book!
Assembly:
– Assemble in reverse sequence 15...1.
Take care for correct position of insulat-
ing flanges in between, correct amount
of gaskets and proper sealing of all
parts to avoid infiltrated air.
– Reconnect cable connection to heater
flange if so fitted.