Dry Type Air Filter - Version A 01.11.1; Dry Type Air Filter - Version A 02.11.2 - Hatz Diesel 1D30 S Workshop Manual

A 02.00 Combustion air
A 02.11 Dry type air filters
–
Version A 02.11.1
Fixation of filter element and cover by flat
washers and Hex.-nuts.
Preparations: –
Dismantling:
– Remove in numerical sequence 1...10.
Inspection/repair:
– Visual inspection.
– Check filter element 6 and sealing strip
around cover 3.
Maintenance according to instruction book!
Assembly:
– Assemble in reverse sequence 10...1.
Torque to specification!
NOTE:
Mind total length of bushing 4 and washer 5
respectively length of bushing 4 without
washer.
Take care for correct position of insulating
flange in between, correct amount of
gaskets and proper sealing of all parts to
avoid infiltrated air.
Conversion:
Possible to current standard in case all parts
in question become replaced.
2
1D . . / 03.06
Version A 02.11.2
Fixation of filter element separately by
retaining plate, flat washers and Hex.-nuts.
Preparations: –
Dismantling:
– Disconnect cable connection from
heater flange if so fitted.
– Remove in numerical sequence 1...12.
– If necessary dismantle cover retaining
screw to replace sealing sleeve (rubber)
between screw cap and cover.
Inspection / repair:
– Visual inspection.
– Check filter element 6 and sealing strip
around cover 1.
Maintenance according to instruction book!
Assembly:
– Assemble in reverse sequence 12...1.
Torque to specification!
NOTE:
Take care for correct position of insulating
flange in between, correct amount of
gaskets and proper sealing of all parts to
avoid infiltrated air.
– Reconnect cable connection to heater
flange if so fitted.
Conversion:
Possible to current standard in case all
parts in question become replaced.