Service Call Errors - Canon Pixma MP530 Service Manual

The remaining ink
amount unknown.
Ink tank not recognized. [1684]
Ink tank not recognized. [1410 to
Scanning unit (printer
cover) is open.
*1: Only for models supporting CD / DVD printing
*2: Only for models not supporting CD / DVD printing
2-2. Service Call Errors (by Cyclic Blinking in Orange (Alarm LED) and Green (COPY button),
or Alarm LED Lit in Orange)
Service call errors are indicated by the number of cycles the Alarm LED and COPY button blink, and the corresponding error
code is displayed on the LCD.
Cycles of blinking
in orange (Alarm
LED) and green
(COPY button)
2 times Carriage error [5100] An error occurred in the carriage encoder
3 times Line feed
error
4 times Purge cam
sensor error
5 times ASF (cam)
sensor error
6 times Internal
temperature
error
7 times Waste ink
absorber full
8 times Print head
temperature
rise error
CHECK INK
[1683]
U130
CHECK INK
U140
CHECK INK
U150
1419][1682]
[1200] COVER IS OPEN
Error
Error
code
signal.
[6000] An error occurred in the LF encoder signal.
[5C00] An error occurred in the purge unit.
[5700] This error takes place when feeding paper from
the ASF after an error occurred in the ASF cam
sensor.
[5400] The internal temperature is not proper.
[5B00] The waste ink absorber is full.
[5200] The print head temperature exceeded the
specified value.
to resolve the error, and then perform manual Print Head
alignment.
An ink tank which has once been empty is installed. Replace
the applicable ink tank with a new one.
Printing with a once-empty or refilled ink tank can damage the
print head.
If printing is continued without replacing the refilled ink tank,
press the Stop/Reset button for 5 sec. or longer to record the
use of a refilled ink tank.
Note:
After the above operation, the function to detect the remaining
ink amount is disabled.
A non-supported ink tank is installed (the ink tank LED is
turned off). Install the supported ink tanks.
An error occurred in an ink tank (the ink tank LED is turned
off). Replace the ink tank(s).
Close the scanning unit (printer cover).
Conditions
1-7
Solution
(Replacement of listed parts, which
are likely to be faulty)
- Carriage unit
- Timing slit film
- Logic board
- Carriage motor
- Timing sensor unit
- Timing slit disk film
- Feed roller
- Platen unit
- Logic board
- Paper feed motor
- Purge unit
- Logic board
- Sheet feed unit
- Logic board
- Carriage unit
- Ink absorber kit
- Print head
- Logic board