Canon Pixma MP530 Service Manual page 48

1 time Platen waste ink absorber
Both the main and platen waste ink
2 times
absorbers
3 times or
Not valid
more
3) Press the ON/OFF button to proceed to the next step.
4) The waste ink amount can be set in 10% increments by pressing the Stop/Reset button. Press the Stop/Reset button the
appropriate number of time(s) to select the value which is closest to the actual waste ink amount.
Time(s)
0 times
1 time
2 times
3 times
4 times
5 times
6 times
7 times
8 times
9 times
10 times or more
5) Press the ON/OFF button to set the selected value to the EEPROM. Print EEPROM information to confirm that the value is
properly set to the EEPROM.
<Button and LCD test procedures>
Confirm the operation after replacement of the LCD unit, Operation panel unit, or Scanner unit.
1) In the Button and LCD test mode, press the Stop/Reset button. The LCD turns black as follows.
Waste ink amount value to be set (%)
0%
10%
20%
30%
40%
50%
60%
70%
80%
90%
Not valid.
Press the ON/OFF button to return to the waste ink amount setting mode.
Not valid for the MP530
Only the main waste ink absorber is valid for the MP530
Press the ON/OFF button to return to the waste ink amount
setting mode.
1-43