Canon Pixma MP530 Service Manual page 47

11 times Orange (Alarm)
12 times Green (COPY)
13 times
Orange (Alarm)
14 times Green (COPY)
15 times Orange (Alarm)
16 times or Green at even
more numbers (COPY)
Orange at odd
numbers (Alarm)
Note: - If the Stop/Reset button is pressed 16 or more times, the Alarm LED (orange) or COPY button (green) lights
steadily without any changes.
- At the end of the service mode, press the ON/OFF button. The paper lifting plate of the sheet feeder unit will be
raised.
<Destination settings procedures>
In the destination settings mode, press the Stop/Reset button the specified number of time(s) according to the destination listed
in the table below, and press the ON/OFF button.
Time(s) LED indication
0 times Green (COPY)
1 time Orange (Alarm)
2 times Green (COPY)
3 times Orange (Alarm)
4 times Green (COPY)
5 times Orange (Alarm)
6 times Green (COPY)
7 times Orange (Alarm)
8 times Green (COPY)
9 times or
Orange (Alarm)
more
Note: After setting the destination without logic board replacement, be sure to initialize the EEPROM. Without
EEPROM initialization, the destination settings may not be valid.
Confirm the model name and destination in service test print or EEPROM information print.
[See 3-4. Verification Items, (1) Service test print, or (2) EEPROM information print.]
<Waste ink amount setting procedures>
Set the waste ink amount data to a replaced new EEPROM after the logic board is replaced in servicing.
1) Before replacement of the logic board ass'y, check the waste ink amount in EEPROM information print.
Verification Items, (2) EEPROM information print.]
2) In the waste ink amount setting mode, press the Stop/Reset button the specified number of time(s) according to the waste ink
absorber whose value should be transferred to the replaced new EEPROM. (Only the main waste ink absorber for the
MP530)
Time(s)
0 times Main waste ink absorber
Button and LCD test
Return to the menu
selection
Return to the menu
selection
Left margin correction
Waste ink amount setting
Return to the menu
selection
Destination
No change of the destination
Japan
Korea
US
Europe
Australia
Asia
China
Taiwan
Return to the menu selection
Waste ink absorber
See "Button and LCD test procedures" below.
Not used in servicing.
See "Waste ink amount setting procedures" below.
1-42
CD / DVD print
Supported
Not supported
Not supported
Supported
Supported
Supported
Supported
Supported
[See 3-4.
Remarks