Service Call Errors - Canon MP830 - PIXMA Color Inkjet Service Manual

2-2. Service Call Errors (by Cyclic Blinking in Orange (Alarm LED) and Green (COPY button), or Alarm LED Lit
in Orange)
Service call errors are indicated by the number of cycles the Alarm LED and COPY button blink, and the corresponding error code is displayed
.
on the LCD
Cycles of blinking in
orange (Alarm LED)
and green (COPY
button)
2 times Carriage error
3 times Line feed error [6000] An error occurred in the LF encoder signal.
4 times Purge cam
sensor error
5 times ASF (cam)
sensor error
6 times Internal
temperature
error
7 times Waste ink
absorber full
8 times Print head
temperature rise
error
9 times EEPROM error [6800] A problem occurred in writing to the EEPROM.
11 times Carriage lift
mechanism
error
12 times AP position
error
13 times Paper feed
position error
14 times Paper feed cam
sensor error
15 times USB Host
VBUS
overcurrent
16 times Valve sensor
error
17 times Motor driver
error
19 times Ink tank
position sensor
error
20 times Other hardware
error
22 times Scanner error
Continuous alternate ROM error
Error
Error
code
[5100] An error occurred in the carriage encoder signal.
[5C00] An error occurred in the purge unit.
[5700] This error takes place when feeding paper from the
ASF after an error occurred in the ASF cam sensor.
[5400] The internal temperature is not proper.
[5B00] The waste ink absorber is full.
[5200] The print head temperature exceeded the specified
value.
[5110] The carriage did not move up or down properly.
[6A00] An error occurred in the AP motor during purging
operation.
[6B00] An error occurred in the paper feed motor.
[6B10] An error occurred in the paper feed cam sensor during
paper feeding from the front paper feed cassette.
This error is also indicated when the waste ink counter
is 60% or more, and a paper jam occurs in the under
guide.
[9000] The USB Host VBUS is overloaded.
[6C00] An error occurred in the valve sensor during cleaning. - Logic board
[6D00] The AD conversion value indicating the motor driver
temperature is not proper.
[6502] None of the ink tank position is detected.
[6500] The PCI bus error is detected by the ASIC.
[5010] The scanner unit cannot detect the home position, or
the scanner unit warming-up is not done properly at
power-on.
On the LCD, "Scanner is not operating correctly." is
displayed.
[6100] The check sum value is incorrect in the ROM check at - Logic board
Conditions
1-6
Solution
(Replacement of listed parts, which are
likely to be faulty)
- Carriage unit
- Timing slit film
- Logic board
- Carriage motor
- Timing sensor unit
- Timing slit disk film
- Feed roller
- Platen unit
- Logic board
- Paper feed motor
- Purge unit
- Logic board
- Sheet feed unit
- Logic board
- Carriage unit
- Ink absorber kit
- Print head
- Logic board
- Logic board
- PR lift shaft
- Sheet feed unit
- Logic board
- Carriage lift sensor unit
- Sheet feed unit
- Logic board
- Purge unit
- Sheet feed unit
- Logic board
- Sheet feed unit
- Logic board
- Logic board
- Purge unit
- Logic board
- Platen unit
- Logic board
- Logic board
- Scanner unit