Users Error Code; Service Call Errors - Canon PIXMA MP750 Service Manual

2-2 User error code
The error codes that have newly been added starting with the product are identified
by the notation "new" those error codes for which remedies unique to the product are
offered are identified by the notation "UNQ (UNIQUE)."
No. Tx or Rx
#001 TX
#003 TX/RX
#005 TX/RX
#009 RX
#011 RX
#012 TX
#018 TX/RX
#021 RX
#022 TX
#037 RX
#085 TX
#995 TX/RX

2-3 Service Call Errors

No. Tx or Rx
##100 TX
##101 TX/RX
##102 TX
##103 RX
##104 TX
##106 RX
##107 RX
##109 TX
Definition
Document has jammed
Document is too long, or page time-over
Initial identification (T0/T1) time-over
Recording paper has jammed or the recording
paper has run out
Polling reception error
The other party has run out of recording paper
Auto dialing transmission error
The other party has rejected the machine
during polling reception
Call fails
Memory has overflowed when receiving
images
Other party does not support ITU-T Color
Faxing
Memory Communication reservation
cancellation
The number allowed for retransmission of the procedure signal
was exceeded during transmission
The modem speed of the machine does not match that of the
other party
Fallback is not possible
EOL cannot be detected for 5 sec (15 sec if CBT)
RTN or PIN has been received
The procedure signal cannot be received for 6 sec while in wait
The transmitting machine cannot be use fallback
After transmitting DCS, a signal other than DIS, DTC, FTT,
CFR, and CRP was received, exceeding the permitted number
of transmissions of the procedure signal
1 - 9
Remarks
Definition