Canon Pixma MP530 Service Manual page 17

DEVICE IN USE
CANNOT TURN OFF
DOCUMENT TOO LONG
PRESS [OK]
MEMORY IS FULL
PRESS [BLACK]
PRESS [COLOR]
BUSY/NO SIGNAL
RECEIVED IN MEMORY
TRY AGAIN IN B&W
NO TEL NUMBER
TX/RX NO. nnnn
TX/RX CANCELLED
HANG UP PHONE
NO ANSWER
NO TONE DETECTED
NO RX PAPER
Unable to turn OFF the machine with [ON/OFF]
because the machine is performing an operation.
The document is too long or is jammed in the
ADF.
The machine s memory is full because you tried to
'
copy too many pages at once or a very detailed
document.
The machine s memory is full because it has
'
received too many documents, or a very long or
detailed document.
[Color] is pressed.
[Black] is pressed.
The telephone number you dialed is busy.
The fax number dialed was incorrect.
The recipient's fax machine is not working.
The recipient is not using a G3 machine.
The touch tone/rotary pulse setting on your
machine is incorrect.
The receiving fax machine did not answer within
55 seconds (after all automatic redialing attempts).
The machine was not able to print the received fax
either because the paper size setting is incorrect or
the ink has run out, and the fax is stored in
memory.
The recipient s fax machine is not color-
'
compatible.
The coded speed dialing code you entered has not
been registered.
When the machine sends or receives a fax, it
assigns a unique identification number (nnnn).
[Stop/Reset] is pressed to cancel the transmission. If required, try sending or receiving again.
The handset is not placed in the handset cradle
correctly.
The recipient s fax machine does not answer.
'
The telephone line cable with a modular plug is
not plugged in properly, or <DIAL TONE
DETECT> is set to <ON>.
The other party s fax machine is out of paper or its Contact the other party and have them load
'
cooled down.
Wait until the operation has finished, then
turn OFF the machine.
Remove the document page jammed in the
ADF, then press [OK]. After resolving the
error, make sure that the document loaded
meets the machine's requirements before
redoing the operation.
Divide the document and copy each part
separately.
Contact the sender and have him/her divide
and resend them.
A temporary error. Press [Black] to continue
the operation.
A temporary error. Press [Color] to continue
the operation.
Try dialing again after waiting for a
moment.
Check the fax number and dial again.
Contact the recipient and have them check
their fax machine.
Contact the recipient and ask them to send or
receive the document using a G3 machine.
Set your machine to the setting that matches
your telephone line.
Contact the recipient and have them check
their fax machine. For an overseas call, add
pauses to the registered number.
Correct the paper size setting or replace the
ink tank.
Press [Black] to resend the faxes.
Register the coded speed dialing code.
Write the number down if you will need it
later.
Replace the handset correctly.
Check the number. Try dialing again after
waiting for a moment.
Make sure that the cable is plugged in
properly, and resend the fax after a while. If
you still cannot send the fax, set <DIAL
TONE DETECT> to <OFF>.
1-12