SPRINTER -
ITEM CODE: BH71-A
ELEVATOR INSTALLATION.
SERVO INSTALLATION.
1. Install the rubber grommets and brass
collets into the elevator servo. Test fit the servo
into the servo tray.
2. Mount the servo to the tray using the
mounting screws provided with your radio sys-
tem.
Elevator servo
HORIZONTAL STABILIZER.
See pictures below:
Top side
.
Elevator servo.
Cut the covering
away from the slot.
INSTRUCTION MANUAL
Assemble then apply drops of thin
C/A to center of hinge,on both sides.
See pictures below:
1. Draw a center line onto the horizontal
stabilizer. Then slide the horizontal into the
fuselage.
Center line
2 Using a modeling knife, cut away the
covering from the fuselage for the stabilizer
and remove it.
Remove covering
3. Mark the shape of the vertical on the
left and right sides onto the horizontal stabi-
lizer using a felt-tip pen
Temporary pin to
keep hinge centered.
15