Table of Contents
Advertisement
SPRINTER -
ITEM CODE: BH71-A
INSTALLING THE ENGINE.
Locate the long piece of wire used for the
throttle pushrod. One end of the wire has been
pre-bend in to a "Z" bend at the factory. This
"Z" bend should be inserted into the throttle
arm of the engine when the engine is fitted onto
the engine mount. Fit the engine to the engine
mount using the screws provided.
105mm
Mark point
10
.
NOSE GEAR INSTALLATION.
Installing steering arm as follow
Adjust the nose gear steering arm until the
arm is parallel with the fire wall.
INSTRUCTION MANUAL
Drill a hole
2mm diameter.
Secure
Steering arm
Advertisement
Table of Contents
