Vertical Installation - Black Horse Model Sprinter Instruction Manual

SPRINTER -
ITEM CODE: BH71-A

VERTICAL INSTALLATION.

See picture below:
Assemble then apply drops of thin
C/A to center of hinge,on both sides.
.
Cut the covering
away from the slot.
Temporary pin to
keep hinge centered.
INSTRUCTION MANUAL

 1) Using a modeling knife, remove the
covering from the top of the fuselage and the
covering from over the precut hinge slot cut
into the lower rear portion of the fuselage This
slot accepts the lower vertical.
Remove covering
2. Slide the rudder into the fuselage as

same as picture below.
3. Mark the shape of the vertical on the

left and right side on the rudder using a felt-tip
pen.
Hinge slot
19