Table of Contents
Advertisement
SPRINTER -
ITEM CODE: BH71-A
Assemble then apply drops of thin
C/A to center of hinge,on both sides.
2. Using a modeling knife, remove the cov-
ering servo tray.
4
.
Cut the covering
away from the slot.
Temporary pin to
keep hinge centered.
Bottom side
Bottom side
Bottom side
INSTRUCTION MANUAL
3. Drill 1,5mm pilot holes through the block
of wood for each of the four mounting screws
provided with the servo. Install servo into ai-
leron servo tray as same as picture below.
Servo tray
4. Using the thread as a guide and using
masking tape, tape the servo lead to the end
of the thread: carefully pull the thread out.
When you have pulled the servo lead out, re-
move the masking tape and the servo lead
from the thread.
Thread
Electric wire
Remove covering
Secure
Bottom side
Advertisement
Table of Contents
