Invacare Fox Service Manual page 57

Hide thumbs Also See for Fox:

Table of Contents

Invacare

- Fox

Refitting the fabric seat:

Position the backrest mounting bracket (2) according to the seat depth, so that the holes (3)

and (4) are aligned.

Slightly tighten the set screws that are located underneath the backrest mounting bracket.

Insert the four Phillips screws (1) and (3) on the right side of the wheelchair frame first.

However, do not tighten the screws completely.

Tighten the textile seat using a large screwdriver or a similar tool, by pressing the screwdriver

in the flap against the chassis (6).

First insert the two middle Phillips screws (5) and then the outer screws (7 and 4) including

washers and tighten these with the corresponding torque (6 Nm).

After this, tighten the screws (1) and (3) to the corresponding torque (6 Nm).

Tighten the set screw.

SERVICE MANUAL

Table of Contents