Invacare Fox Service Manual page 50

SERVICE MANUAL
Removing the motor/transmission unit:
·
Loosen the four Allen screws (4) with a 5 mm Allen key.
·
Remove the screws (4) together with the washers.
·
Pull the motor transmission unit (3) downwards out of the chassis. Take into account the heavy
weight of the unit.
·
Replace the drive unit.
Refitting the motor/transmission unit:
Note
Before refitting a new motor-transmission unit, check to see whether this should be fitted to the
left-hand or right-hand side of the mobility device. The drive units are different. Note the labelling
on the motor plug.
·
Refit the motor transmission unit in the reverse order.
·
Reconnect the motor cable (2) to the power module.
·
Make sure that the motor cable cannot be pinched or bent, and that it is not exposed to chafing
in any place.
·
Tighten the screws (4) to 7 Nm +/-1 Nm.
·
To conclude, you should always carry out a trial run to test the vehicle functions.
50
®
Invacare - Fox