Selecting A Location For The Dispenser - lancer Flavor Select 30 Installation And Service Manual

1.2 DRAIN SPIDER - CONTINUED
If the drain spider is not in place, proceed with the following steps:
A. Remove agitator clip and pin from agitator bar (Fig 2).
B. Remove agitator bar from the hub.
C. Remove ice shroud by lifting the side opposite the auger and rotating out from
beneath the auger.
D. Locate drain spider and reinstall in the coldplate cavity where drain line exits.
E. Reinstall all components. Ensure agitator clip is locked Fig 2.
1.3 SELECTING A LOCATION
Connecting lines can be run through the back of the dispenser or extend down through a counter
cutout. Seal the dispenser directly on the countertop. Counter Cutouts are located in the Section 5.
Illustrations, Parts Listings and Wiring Diagrams.
A. Select a level, well ventilated, accessible location away from direct sunlight
(avoid) or overhead lighting (convenient to water, soda, and syrup lines and
open type drain), a properly grounded electric supply and ensure sufficient
clearance for air circulation.
B. Sufficient clearance must be provided, if an ice maker is not installed, to allow
filling the ice compartment from a five gallon bucket (a minimum of 16 inches
(106.4 mm) is recommended), refer to Fig 3. Lancer does NOT recommend the use of shaved
or flake ice in the dispenser.
B. The selected location should be able to support the weight of the dispenser,
ice and possibly an ice maker being installed after counter cut out is made.
Total weight (with ice maker) could exceed 800 pounds (363.6kg).
C. Unit may be installed directly on the countertop or on legs. If installed
directly on the counter, the unit must be sealed to the countertop with an
FDA approved sealant. If an ice maker is to be mounted on top of dispenser, do not install
dispenser on legs.
D. The dispenser is only to be installed in locations where it can be overseen by
trained personnel.
NOTE: The ice level should not exceed the height of the metal bin wall when filled manually (Fig 3).
FIGURE 3. Unit Displayed (no icemaker)
NOTE: Fill ice with merchandiser intact.
Installation and Operation Manual PN 28-0580/03
FIGURE 2
FS22 DISPENSER, NO ICEMAKER
ENSURE SUFFICIENT CLEARANCE
9
FOR FILLING WITH ICE
ENSURE KEYSWITCH
IS ACCESSIBLE