Installation; Unpacking The Dispenser; Drain Spider - lancer Flavor Select 30 Installation And Service Manual

Flavor Select (FS) 22 Ice Beverage Dispenser

1. INSTALLATION

BEFORE GETTING STARTED
Each unit is tested under operating conditions and is thoroughly inspected before shipment. At the time of
shipment, the carrier accepts responsibility for the unit. Upon receiving the unit, carefully inspect the
carton for visible damage. If damage exists, have the carrier note the damage on the freight bill and file a
claim with carrier. Responsibility for damage to the dispenser lies with the carrier.
THINGS TO CONSIDER:
Connecting lines can be run through the back of the dispenser or extend down through a counter cutout.
Seal the dispenser directly on the countertop.
1.1

UNPACKING THE DISPENSER

A. Set shipping carton upright on the floor. Cut band and remove. Remove any staples that
secure the shipping board and lid to the carton. Open top of carton and remove interior
packing.
B. Lift carton up and off of the dispenser. Remove wood shipping base from the bottom of the
dispenser. (Support dispenser while removing shipping base to prevent damage to the
dispenser.)
C. Remove installation parts kits from the ice compartment.
D. Inspect unit and parts for concealed damage(s). If damage exists, notify delivering carrier
and file a claim against the carrier.
E. To remove the merchandiser: remove the two (2) screws on the Faucet Plate that secure
the merchandiser. The two (2) screws are located (from the left), above the second and
third nozzle and the sixth nozzle.
1.2

DRAIN SPIDER

The drain spider (Fig 1) is located to the right side near the front of the bin under the ice shroud.
The coldplate has a cavity designed to hold the drain spider. During shipment or installation, the
drain spider may become dislodged from its original position.Prior to installing the dispenser, en
sure the drain spider is in the correct position.This will prevent drain clog issues. Inspect the lower
bin area and reach under the shroud to ensure the drain spider is secure in the coldplate cutout.
FIGURE 1
CONTINUED ON NEXT PAGE
8