lancer Flavor Select 30 Installation And Service Manual page 25

TROUBLE
4.7 Valves do not operate.
4.8 Water in ice bin
4.9 Water leakage around nozzle.
4.10 Miscellaneous leakage.
4.11 Noisy/cavitating carbonator
pump
4.12 Insufficient soda flow
(carbonated drinks).
4.13 Insufficient water flow (plain
water).
CAUSE
A. Keyswitch is off, or keyswitch
harness is disconnected.
B. Circuit breaker tripped.
C. Unit not plugged in.
A. Coldplate drain is obstructed.
A. Damaged or improperly
installed o-ring on nozzle
A. Gap between parts.
B. Damaged or improperly
installed o-rings
A. Insufficient incoming water
supply pressure.
A. Insufficient CO2 supply
pressure.
B. Shutoff on mounting block not
fully open.
C. Foreign debris in soda flow
control.
A. Insufficient incoming supply
pressure.
B. Shutoff on mounting block not
fully open.
C. Foreign debris in water flow
control.
D. Water filtration problem.
25
Installation and Operation Manual PN 28-0580/03
REMEDY
A. Turn keyswitch and/or make
sure keyswitch harness is con-
nected.
B. Reset circuit breaker.
C. Plug in dispenser
A. Remove splash plate to obtain
access to drain tubes and clear
accordingly.
A. If damaged, replace. If improp-
erly installed, adjust
A. Tighten appropriate retaining
screws.
B. Replace or adjust appropriate
o-rings.
A. Verify incoming supply water
pressure to carbonator pump is a
minimum of 25 PSI, 1.7 bar(max
50 PSI, 3.4 bar).
A. Verify incoming CO2 pressure
between 70-75 PSI (4.8-5 bar)
B. Open shutoff fully.
C. Remove soda flow controlf rom
valve and clean out any foreign
material to ensure smooth spool
movement.
A. Verify incoming supply water
pressure to plain water inlet is a
minimum of 70 PSI, 4.8 bar (max
125 PSI, 8.6 bar).
B. Open shutoff fully.
C. Remove water flow control from
valve and clean out any foreign
material to ensure smooth spool
movement.
D. Service water system as re-
quired.
CONTINUED ON NEXT PAGE