lancer Flavor Select 30 Installation And Service Manual page 21

MENUS AND SUBMENUS
1. Bonus Flavors
a. Decide if the bonus flavors will be set to add an injected flavor to the brands or dispense
carbonated water/plain water.
b. Choose the Valve number (1-4) by scrolling UP and DOWN arrows.
c. Use the LEFT and RIGHT arrows to shift to the Top, Middle, or Bottom "bonus" flavors
categories.
d. Press the UP and DOWN arrows under Top, Middle, or Bottom to select it as an injected
flavor, carbonated Soda water, or plain Water.
e. Press ENTER to finalize settings. Panel lights should confirm finalized configurations.
2. Brands
a. Decide how the brands will be setup.
b. Choose the Valve number (1-4) by scrolling UP and DOWN arrows.
c. Use the LEFT and RIGHT arrows to shift to the Left or Right categories. The Left or Right
categories are set with the assumption that you are looking at them from the front.
d. Press UP and DOWN arrows under Left (1-2) or Right (1-2) to select the brand per side as
a single or double. For example, for bezel PN 05-2120, V:1 L:1 R:2
3. Soda/Water
a. Decide which switch locations will be carbonated and/or non-carbonated drinks.
b. Choose the Valve number (2-3) by scrolling the UP and DOWN arrows.
c. Use the LEFT and RIGHT arrows to shift to the number categories (1-4). The number
categories correspond to the brand location (per valve) that is being configured.
d. Press the UP and DOWN arrows under the number to select if that brand will be
carbonated Soda or non-carbonated plain Water. If a single brand per side, only number 1
and/or 3 need to be set.
4. Automatic Agitation
a. Each Series 14400 ice beverage dispenser is equipped with automatic agitation for the
ice bin. The unit is shipped with timing set at two seconds (2000 milliseconds) ON every
sixty minutes for cubed ice. The unit is shipped with timing set at four seconds
(4000 milliseconds) ON every 150 minutes for pellet ice.
Installation and Operation Manual PN 28-0580/03
21