Yealink IP Phones Auto Provisioning Guide
Parameter
network.span_to_pc_port
network.snmp.enable
(only applicable to SIP-T48G IP phones)
76
Permitted
Descriptions
Values
to 3600
phone to send the CDP (Cisco Discovery Protocol)
request.
The default value is 60.
It takes effect after a reboot.
Note: It works only if the value of the parameter
"network.cdp.enable" is set to 1 (Enabled).
It enables or disables the IP phone to span data
packets received from the WAN (Internet) port to
the PC (LAN) port.
0-Disabled
1-Enabled
0 or 1
If it is set to 1 (Enabled), all data packets from
WAN port can be received by PC port.
The default value is 0.
It takes effect after a reboot.
It enables or disables the SNMP (Simple Network
Management Protocol) feature on the IP phone.
0-Disabled
0 or 1
1-Enabled
The default value is 0.
Web Setting Path
Interval (1~3600s)
Network->Advanced->Span to
PC->Span to PC Port
Network->Advanced->SNMP->Activ
e