Yealink SIP T2 Series Provisioning Manual page 81

Parameter
network.lldp.enable
network.lldp.packet_interval
network.cdp.enable
network.cdp.packet_interval
Permitted
Values
It enables or disables the LLDP (Linker Layer
Discovery Protocol) feature on the IP phone.
0-Disabled
0 or 1
1-Enabled
The default value is 1.
It takes effect after a reboot.
It configures the interval (in seconds) for the IP
phone to send the LLDP (Linker Layer Discovery
Protocol) request.
Integer from 1
The default value is 60.
to 3600
It takes effect after a reboot.
Note: It works only if the value of the parameter
"network.lldp.enable" is set to 1 (Enabled).
It enables or disables the CDP (Cisco Discovery
Protocol) feature on the IP phone.
0-Disabled
0 or 1
1-Enabled
The default value is 1.
It takes effect after a reboot.
Integer from 1 It configures the interval (in seconds) for the IP
Descriptions
Network->Advanced->LLDP->Active
Network->Advanced->LLDP->Packet
Interval (1~3600s)
Network->Advanced->CDP->Active
Network->Advanced->CDP->Packet
Appendix
Web Setting Path
75