Connecting The Power Cable - MUTOH Rockhopper II User Manual

3 Basic Installation

3.2 Connecting the power cable

The connection procedure for the power cable is explained below.
WARNING
• • • •
Make sure that the distributed power cable is used. Use of a different cable may
result in electric shock or fire.
• • • •
Do not use a damaged power cable. Doing so may result in electric shock or
fire.
• • • •
The disconnect device is the plug on the power supply cord.
CAUTION
• • • •
Be careful of the following when handling the power cable.
• • • • Do not make any modifications to the power cable.
• • • • Do not place anything heavy on the power cable.
• • • • Do not bend, twist, or pull the cable.
• • • • Do not wire the cable near equipment that generates heat.
NOTE
•
If the power cable is damaged, contact one of the following locations.
• The shop where you bought your MUTOH printer
• Nearest MUTOH local dealer
To connect the power cable, follow the steps below.
1. Make sure that the printer is off.
F 1
F 3
ERROR
DATA
RECEIVE
MENU
PROCESS
MEDIA SET
CANCEL ENTER
MEDIA
ROLL
SHEET
3-2
Rockhopper II - User's Guide
F 2
F 4
POWER