Connecting The Power Cable; Installation Procedure - MUTOH RJ-900X series Installation Manual

411

Installation procedure

Install this product to the installation place in
accordance with the list shown below1
4.2.1 When using the printer
with the stand
NOTE
Please check that the butterfly bolts are not
z
loose before/after carrying this product1
When transferring or carrying outside, sepa-
rate the printer and the stand1
11
Check that the two butterfly bolts attaching
the stand and the printer are not loose1
21 Carry the printer to the installation place1
31 Lock two casters on the front side1
No1 Name No1
1 Casters 2 Caster locks
41
Check that the two butterfly bolts attaching
the stand and the printer are not loose1
4.2.2 When using the printer
only (RJ-901X)
11
Install the printer so that the rubber foot (front) of
the product is placed on the front of the board1
NOTE
z When using the printer only (without the
stand), always arrange as shown below1
There is a possibility that the printed sheets
are affected or errors such as media jams oc-
cur1
No1 Name
1 Rubber feet
5

Connecting the power cable

This section explains how to connect the power
cable1 Follow the steps below to connect the
power cable1
WARNING
Be sure to use the specified power
z
cable1 Using a power cable other than
the specified can cause an electric
shock or fire1
Use the power cable compliant with
z
the safety standards, power-supply
voltage, and plug shape of the country
where the printer is used1
Use a power cable which is equipped
z
with a protective earth, and securely
connect it to the outlet1
Do not use a damaged power cable1 It
z
could lead to an electric shock or fire1
11 Confirm that the product is turned OFF1
Name
21
Connect the power cable to the AC inlet on
the back of the product1
No1 Name
1 AC inlet
31
No1
No1 Name
2 Power cable
5
RJ-900X series INSTALLATION MANUAL
Correctly insert the power cable plug into the
power socket1
Name
1 Power cable
RJ900XE-I-00