4.1. CONNECTING THE POWER CABLE
Step 1 :
Make sure the printer's power switch is turned OFF.
Step 2 :
Plug the printer-end of the power cable into the connector at the back of the printer.
Step 3 :
Plug the other end of the power cable into an electrical outlet of the correct voltage and with a
proper grounding.
Power supply:
•
100-120V
Voltage:
•
Frequency:
•
Current:
Note:
When you turn off the power, please note that your printer needs about five seconds to
perform its shut down sequence.
To this end, wait for at least five seconds to switch the printer on again.
The disconnect device is the plug on the power supply.
4. PREPARING FOR A JOB
200-240V
50/60 Hz
50/60 Hz
6.8A
3.4A
Falcon Outdoor Jr. – Operation Instructions
Page
31
PN: MAI-75039
Rev. 1.A – 07/26/05