Table of Contents
Advertisement
Installation Procedures
CONNECTING THE POWER CABLE / DISCONNECT DEVICE
1) Make sure the printer's power switch is turned OFF.
2) Make sure the power of the Heating System and the Roll Take-Up System are turned
OFF.
3) Plug the printer-end of the power cable into the connector at the back of the printer.
4) Connect the cable of the Roll-Take-Up System with the Printer body.
5) Plug the other end of the power cable into an electrical outlet of the correct voltage and
with a proper grounding.
• Power supply:
- Voltage:
- Frequency:
- Current:
Note:
• When you turn off the power, please note that your printer needs a
• To this end, wait for at least five seconds to switch the printer on
• The disconnect device is the plug on the power supply cord.
200 to 240 VAC or 100 to 120 VAC
50/60 Hz ± 1 Hz
< 10 A (110 V)
< 5 A (220 V)
few seconds to perform its shut down sequence.
again.
Operation Instructions Rockhopper Printer
33
Page
AP-75024 Rev. 1.2. – 18/08/2002
Advertisement
Table of Contents
