Network Configuration By Hyper Terminal - HIKVISION DS-9500 Series User Manual

User Manual of DS-9500 Series NVR

2.2 Network Configuration by Hyper Terminal

Enter Hyper Terminal
Click "Start"->"Programs"->"Accessories"->"Communications"->"Hyper Terminal"->"HK", then the Hyper
Terminal interface will appear as figure below. Type "Enter", and the prompt "[root@dvrdvs/]#" will appear which
means connection between RS232 interface of PC and RS232 interface of NVR is established successfully by
Hyper Terminal. The following operation commands are to accomplish the parameters setup in the prompt.
Figure 2.2.1
Commands
helpm Console help command is used to print common commands, show as Figure 2.2.1.
Show the current IP address of NVR. Command format: getIp "Enter".
getIp
Setup NVR IP address. Command format: setIp IP: mask
setIp
e.g. setIp 192..168.1.11:255.255.255.0
Show the current port of NVR. Command format: getPort "Enter".
getPort
Setup NVR port. Command format: setPort Port
setPort
e.g. setPort 9000
Show current NVR gateway address. Command format: getGateway "Enter".
getGateway
Setup NVR gateway. Command format: setGateway Gateway
setGateway
e.g. setGateway 192.168.1.1
Utilities
15