Table of Contents
Advertisement
User Manual of DS-9500 Series NVR
Step3: Click the Virtual Disk tab to
return to the Virtual Disk interface to
check the rebuilding status under Task
bar.
Rebuilding Array Manually
When the system has detected HDD exception or the array is in Degraded status, you can select the idle physical
HDD for manual rebuilding of array.
Step1: Select array for rebuilding.
1)
Enter the RAID Settings menu by clicking
Config > Remote Config >RAID Configuration.
2)
Select the Array tab to enter the Array interface.
3)
Select the array for rebuilding.
4)
Click the Rebuild button to enter Rebuild Array
interface.
Step2: Select physical HDD for array rebuilding.
1)
Select the physical HDD for array rebuilding.
2)
Click the OK button to confirm the array
rebuilding
Note:
Make sure virtual disks have been created
before operating array rebuilding; otherwise,
corresponding message box will pop up.
61
Advertisement
Table of Contents
