Network Menu; Energy Saver Menu - Epson AL-M8200 Series User Manual

AL-M8200/AL-M8100/AL-M7100 Series User's Guide
Item
Buffer Size

Network Menu

See the Network Guide for each setting.
Note:
After any item in the menu is changed, the setting takes effect after a warm boot or after the power is turned on again.
While it is reflected in the Status Sheet and EJL read-back, the actual change takes effect after a warm boot or after the
power is turned on again.

Energy Saver Menu

Item
Time to Sleep(Auto)
Time to Sleep
Reset Operate History
Getting to Know Your Printer
Explanation
Determines the amount of memory to be used for receiving data and printing data.
Note:
❏ To activate Buffer Size settings, you must turn off the printer for more than five
seconds then turn it back on. Or, you can perform a Reset All operation, as
explained in Reset Menu.
❏ Resetting the printer erases all print jobs. Make sure the Ready light is not
flashing when you reset the printer.
Settings (default in bold):
Normal, Maximum, Minimum
Explanation
When this setting is set to Enable, the printer automatically determines the time to enter
the sleep or deep sleep mode, based on the operation history of the printer. Note if Enable
is selected, the Time to Sleep and Eco Fuser settings are ignored.
Settings (default in bold):
Enable, Disable
Specifies the length of the time until the printer enters the sleep mode or deep sleep mode
if there are no button operations and no jobs to be printed.
Settings (default in bold):
1Min, 3Min, 5Min, 15Min, 30Min, 60Min, 120Min
Resets the printer's operation history, which is based on the Time to Sleep(Auto)
calculation.
Note:
You need to use EpsonNet Config with a web browser to reset the history, because this
item is not displayed on the control panel. See the Network Guide for the procedure to
access EpsonNet Config with a web browser.
21