B (Cover B) - Epson AL-M8200 Series User Manual

AL-M8200/AL-M8100/AL-M7100 Series User's Guide
D
Pull handle D obliquely up to draw out the
developer unit.
E
Remove jammed paper.
c
Important:
Do not touch the transfer roller, which is
black, to avoid damaging it.
F
Push handle D until the developer unit locks.
G
Close cover F, then cover A.
Troubleshooting

B (Cover B)

A
Open cover B, which is on the back of the printer.
!
B
Open the inner cover, and then remove jammed
paper.
C
Close cover B.
66
Caution:
❏ Unless specifically instructed in this
guide, be careful not to touch the fuser,
which is marked with a caution label,
or the surrounding areas. If the printer
has been in use, the fuser and the
surrounding areas may be very hot. If
you must touch one of these areas, wait
40 minutes to allow the heat to subside
before doing so.
* caution label
❏ Do not insert your hand deep into the
fuser unit as some components are
sharp and may cause injury.